I just upgraded from 7.7.0-761 to 8.0.6-191. Everything appeared to go smoothly but after the appliance rebooted I was no longer able to access the web GUI via HTTPS and was also not able to SSH to the box. Does anyone know what may have caused this and is there a way to get this resolved remotely? Any help would be appreciated.
I should also mention I can reach the WSA via ICMP and the customer says it's working okay. They have some work stations that are manually set through their browsers to go to the WSA and some workstations that use WCCP. WCCP doesn't seem like its working, I cleared the counters last night and don't see any hits.
Service Identifier: 10 Number of Cache Engines: 0 Number of routers: 0 Total Packets Redirected: 0 Redirect access-list: ironport_users Total Connections Denied Redirect: 0 Total Packets Unassigned: 0 Group access-list: -none- Total Messages Denied to Group: 0 Total Authentication failures: 0 Total Bypassed Packets Received: 0 ASA#
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...