I just recently purchased two S650s for my organization assuming that it could be configured like our C150s (clustered). Now that I actually hooked up the second device I found my assumption to be wrong. What is the best way to configure them for load balancing with a single domain using a single Cisco Router with transparent redirection. I already configured them both almost identically and they appear to be load-sharing the client traffic. I just wanted to verify there isn't a better way.
Thanks for the reply. I have the devices configured for client-based load-balancing. Everything appears to be working. I also notice on my daily reports that the devices have a evenly distributed number of clients attached to each device. I think this load-balancing and fail-over option will meet our needs better than just a fail-over cluster configuration. Being that my organization is small, my cpu load on each device is extremely small. I was just wondering what the refresh time is as far as client connections? Will I get a daily report for each device that contains all clients or will the report look like it does now in the morning with just a split group of clients on each device?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...