Hi, I'm installing an Ironport S-Series and testing it and all seems to work ok but there is no log or system report. In System Overview page I cannot see anything in any time range and obviously I cannot see access log.
Also if I tried to go by ftp I can connect to Ironport but there is nothing in directory. Finally I've tried to do a tail or grep by CLI but same problem.
Actually I'm using demo licenses until we install the appliance on client site, could it be the problem?.
I'm using release 7.1.0-307 and management port for all traffic.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...