Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
New Member

Shutdown Interface command Ironport

Hi everybody!

Ironport has a "shutdown" command to disable the interfaces ?

Thanks.                 

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Shutdown Interface command Ironport

The only way to disable interfaces is by removing the interface from the configuration. There is no "shutdown" command for interfaces.

You can remove interfaces through both the CLI and GUI.

To do it in the gui go to "Network" -> "Interfaces" -> "Edit".

Once you do that remove all the information from whatever interface you want to disable.

The cli is a little bit easier. Type the following commands in order.

"interfaceconfig" -> "delete" -> Interface # -> Answer "y"

Christian Rahl

Customer Support Engineer                      

Cisco IronPort - Web Security Appliances

Cisco Technical Assistance Center RTP

United States Ironport: 1-877-641-IRON (4766)

4 REPLIES
New Member

Shutdown Interface command Ironport

The only way to disable interfaces is by removing the interface from the configuration. There is no "shutdown" command for interfaces.

You can remove interfaces through both the CLI and GUI.

To do it in the gui go to "Network" -> "Interfaces" -> "Edit".

Once you do that remove all the information from whatever interface you want to disable.

The cli is a little bit easier. Type the following commands in order.

"interfaceconfig" -> "delete" -> Interface # -> Answer "y"

Christian Rahl

Customer Support Engineer                      

Cisco IronPort - Web Security Appliances

Cisco Technical Assistance Center RTP

United States Ironport: 1-877-641-IRON (4766)

New Member

Shutdown Interface command Ironport

Thanks Christian!

Cisco Employee

Re: Shutdown Interface command Ironport

Shutdown is used to ³power off² the WSA gracefully from the CLI

Regards,

Zack

On 6/12/12 1:18 PM, "Mafiaboy401"

Re: Shutdown Interface command Ironport

Hi,

No. We have no shutdown command available.

If you are interested in having this feature, please open a case and we will

provide you with a Feature Request form.

Regards,

Valter

On 6/12/12 2:18 PM, "Mafiaboy401"

2136
Views
0
Helpful
4
Replies
CreatePlease login to create content