08-07-2012 08:51 PM
Hi,
Recently i have implemented cisco wave 274 - k9 in our branch office, the site is up and running. but the main challenge we are facing is unable to by pass the WAVE when any power issue with the same.I have tried some BIOS setup option,no luck. please provide your suggestion to make the site up and running if any issues with the box.
Thanks in advance ...!
08-08-2012 09:54 AM
hi,
How is the WAVE configure with WCCP ? inline ? or PBR?
Regards,
09-13-2012 10:27 PM
Hi,
It is confgured as inline only.
Regards,
solaikumar.k
09-14-2012 12:04 AM
please configure All inline interfacegroup
# failover timeout 5
reagrds
support netplace
09-14-2012 08:07 AM
hello Solaikumar,
if there's any power issue or a kernel crash with the WAAS device the traffic still go through the inline card, I suspect that there might be a hardware failure with the inline card but before replacing it make sure you follow the inline installation cabling guide properly
here are some samples of cabling:
I would not change the failover timeout to 5 because the default one is 1 second, I don't see a direct relation to your problem anyways.
good luck!
09-14-2012 11:03 PM
Thanks for the reply Felix & Netplace
@ Felix , This is the new box which we got as an RMA from cisco,I suspect ther is no issue with the box. could you share any mandatory bypass configuration.
Thanks in advance.
Warm Regards,
solaikumar.k
09-19-2012 02:14 PM
I am inclined to agree with Felix on this one. Hardware failure, open a TAC case. Here is the inline configuration from one of my 274s:
interface InlineGroup 1/1
inline vlan all
no autosense
bandwidth 100
full-duplex
exit
The only times I have had power issues, it has been the entire site that lost power, not just my device. However, I have rebooted it multiple times with no issue in connectivity when it was rebooting. I did have one 274 have a complete system failure and when it went down, it would not come back up, and it properly failed over to bypass (also using inline like you). I do not believe the configuration comes into play when the device has no power, it kind of either works or doesn't...
09-20-2012 12:31 AM
Dear Beau,
Thanks for the reply !!
As I told before this is the new box which is working well. even we have rebooted multiple times,but no luck.
Regards,
solaikumar.k
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide