02-27-2012 06:53 PM
If I need to change the RADIUS or TACACS+ servers IP addresses for the CM authentication, can I just make the change in the CM GUI page? Or I should access the CM using CLI and change the device to "local authentication" before changing the RADIUS / TACACS+ details?
Thanks!
Joe
Solved! Go to Solution.
02-28-2012 01:27 AM
Hi Joe,
You should be able to do it directly from the CM. However, I would strongly recommend you to change to local authentication first in case there are any issues. If you don't, you may get locked out of your devices.
Regards
Daniel
02-28-2012 01:27 AM
Hi Joe,
You should be able to do it directly from the CM. However, I would strongly recommend you to change to local authentication first in case there are any issues. If you don't, you may get locked out of your devices.
Regards
Daniel
03-05-2012 01:37 AM
Thanks Daniel for your answer!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: