Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Change the authentication settings of the CM

If I need to change the RADIUS or TACACS+ servers IP addresses for the CM authentication, can I just make the change in the CM GUI page? Or I should access the CM using CLI and change the device to "local authentication" before changing the RADIUS / TACACS+ details?

Thanks!

Joe

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Change the authentication settings of the CM

Hi Joe,

You should be able to do it directly from the CM. However, I would strongly recommend you to change to local authentication first in case there are any issues. If you don't, you may get locked out of your devices.

Regards

Daniel

2 REPLIES
Cisco Employee

Change the authentication settings of the CM

Hi Joe,

You should be able to do it directly from the CM. However, I would strongly recommend you to change to local authentication first in case there are any issues. If you don't, you may get locked out of your devices.

Regards

Daniel

New Member

Change the authentication settings of the CM

Thanks Daniel for your answer!

379
Views
0
Helpful
2
Replies