Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Changing admin password

Hi,

I want to change the default admin password on the all WEAs currently registered within my CM. So I would like to ask, if I change this password for these devices using CM (Admin > Password section of the GUI), what about the new installed and registered devices in the future? Does the default password change automatically when the new WAE registeres with CM or do I have to change the password manually?

Many thanks!

Stan

1 REPLY

Re: Changing admin password

Stan,

You should not have to manually change the admin password for newly added/registered WAEs.  Once the newly added WAE is listed as online, receives a full CMS update, and has no alarms present you should then have to login to the WAE CLI with the new admin password.

Note, I just tested this in my lab by de-registering a WAE from the CM, restoring it to factory defaults, changed the admin password from the default on the CM GUI, then registered the WAE to this CM.  Once it was listed as online in the CM and all the alarms were cleared (I was missing the license at first), the next time I tried to telnet to it I had to use the updated admin password.

Hope this helps,

Mike Korenbaum
Cisco WAAS PDI Help Desk

http://www.cisco.com/go/pdihelpdesk

233
Views
0
Helpful
1
Replies