cisco 4506 PBR failure detection solution ?

[chia hao chang]

hi all

I use PBR to redirect traffic to wae in cisco 4506

4506 IOS ver is enterprise12.2(46) SG

supervisor 4

in waas configuration guide

when use PBR to redirect traffic to wae

it have 3 method to verify wae is available

but the sample configuration are all in router environment

it use command "set ip next-hop verify-availability 1.1.1.1 track 1"

to verify wae status

but

in 4506, it has not command "verify-availability"

although, I use ip sla to track wae status

cisco 4500 series is common use in small business

could anyone please share the solution to solve this question with me

thanks

[Bhavin Yadav]

Hi Chia,

You may want to take this question in Lan Switching Routing forum as it is related more to the Lan Switching / Routing commands and references..

https://supportforums.cisco.com/community/netpro/network-infrastructure/switching

About the WAE setup, all it cares in line setup is to pass the traffic in transparent way. In the WCCP / PBR setup, all it does is receives the traffic and sends it back out to the origin tunnel interface / default gateway depending on your configuration.

Hope this helps.

Regards.