Without writing a book, WAAS uses TCP optimization and compression for all TCP traffic that is redirected to it. Also, on top of the basic TCP optimizations, there are also Layer 7 Application Optimization(AO). Currently in 4.0 there is a CIFS AO, but in future releases (4.1.x), there will be more AOs for things like HTTP, NFS, RTSP, etc.
Check out the following for a little more detail...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...