Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Dual routers with only one WAE module

Hello all,

I have dual routers (router A and router B)each connects to a separate WAN provider and HSRP is enabled between the two routers. Here are my questions. Given that I only have one WAE module in router A and I've created a new subnet for WAAS and the "interface Integrated-Service-Engine" and the Service-module are in the same subnet. Do I need to create another sub-interface on router B for WAAS ? Where would I enable WCCP on router A and router B ?

thanks in advance !!!

Danny

1 REPLY
New Member

Re: Dual routers with only one WAE module

The wae module have two interfaces; one internal that comes when we install the module on router and the external interface. It answers one of your questions, the router without wae module there is no way to appear the internal interface.

But the wae module can only optimize traffic on one interface, could be the internal or the external, not both. So you have to configure the wccp to both routers redirect the traffic to same interface, internal or external; and have in mid that the wae module will return the traffic to one default gateway only.

Because of that, a design with the external interface connected to a new vlan, with subinterfaces on each router, routing on this new vlan, passive interface on old vlan and some kind of hsrp between the routers would work.

265
Views
0
Helpful
1
Replies