Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Gig1/0 shuts itself

Hello team,

is  there any particular reason why the management interface Gig1/0 (set as primary int) can shut  itself? It is configured to autosense. WAE type is WAE-674-K9 with  oe674-4.1.5f.2 IOS version. I tried to change the speed and duplex settings but when I type "no shut" it still remains in admin down status.

Many thanks!

Stan

1 REPLY
Cisco Employee

Re: Gig1/0 shuts itself

Hi Stan,

Please make sure to follow-up the cabling guidelines mentioned here: Cabling

I know above link is for inline adapter but it remains true for gig 1/0 while using WCCP, too..

You may want to try same thing on gig 2/0. If the same issue continues with gig 2/0, it may be the cabling or the interface issue on router / switch where it is connected.

Can you paste the sh int g 1/0 interface output here while it is workign and not working ?

What is the status of interface (on switch / router) connected to WAAS gig 1/0 when it shows down?

If the issue continues, you may want to open up a TAC case as this may be the hardware issue on interface itself.

227
Views
0
Helpful
1
Replies