is there any possibility within CM software to block incoming registrations from remote WAAS devices, please? I assume that I can use ACL to permit only IP addresses of "approved" appliances. Is there any other way (based on device ID, etc.)?
In case of using ACL, should I permit ONLY ports 443 and 8443 as a destination or are there any other ports used for communication with CM?
I found out that I can configure CM not to automatically activate newly registered appliances. What exactly is and what is not exchanged between CM and particular device in "Inactive" state, please?
Introduction This article will help you understand the steps on how to
download the UCS licenses from the Cisco Systems website and then
installing it on the UCS. The redacted (blue lines) just covers up
certain numbers for privacy please do not take them...
Introduction This article will help you understand and educate the
customer on how to clear their "expired licenses"
(license-graceperiod-expired) from their UCS-M. If a customer just
purchased a license and needs a step by step guide on how to download
==================== VIC FNIC driver does not support Virtual Volumes (
second level LUN ID ) An enhancement request has been created to track
this feature - CSCux64473 UPDATE - 12-14-2016 We made some traction on
the enhancement request - The Fix is in t...