On the router/switch run 'show ip wccp 61- detail' will list all the WCCP clients and the buckets they own. On each WAE (WCCP client) you can run 'show ip wccp flow tcp-promiscuous detail' (adding 'detail' will give you a little more information for each WCCP bucket owned by that WAE. All devices in the WCCP cluster must agree on who owns what bucket. The WAE with the lowest IP address will take the lead in the farm and decides which WAE owns which bucket.
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...