Service Identifier: 61 Number of Service Group Clients: 1 Number of Service Group Routers: 1 Total Packets s/w Redirected: 1 Process: 0 CEF: 1 Redirect access-list: -none- Total Packets Denied Redirect: 0 Total Packets Unassigned: 0 Group access-list: -none- Total Messages Denied to Group: 0 Total Authentication failures: 0 Total Bypassed Packets Received: 0
Service Identifier: 62 Number of Service Group Clients: 1 Number of Service Group Routers: 1 Total Packets s/w Redirected: 11 Process: 0 CEF: 11 Redirect access-list: -none- Total Packets Denied Redirect: 0 Total Packets Unassigned: 0 Group access-list: -none- Total Messages Denied to Group: 0 Total Authentication failures: 0 Total Bypassed Packets Received: 0
vlan 1 and 2 : data
vlan 3 routeurs
vlan 4 : WAE
interface Vlan1 ip address 10.0.0.1 255.255.0.0 ip wccp 61 redirect in standby 0 preempt standby 1 ip 10.0.0.6 standby 1 priority 150 standby 1 preempt standby 1 name hsrp_vlan_1 ! interface Vlan2 ip address 10.1.0.1 255.255.0.0 ip wccp 61 redirect in standby 2 ip 10.1.0.6 standby 2 priority 150 standby 2 preempt standby 2 name hsrp_vlan_2 ! interface Vlan3 description Routage-FT ip address 192.168.1.4 255.255.255.0 ip wccp 62 redirect in standby 3 ip 192.168.1.6 standby 3 priority 150 standby 3 preempt standby 3 name hsrp_vlan_3 ! interface Vlan4 description VLAN WCCP ip address 192.168.100.1 255.255.255.0
Re: L2 redirection between a 3750 and WAE 674 WCCP
This counter on the 3750 is a software counter, but all WCCP redirection should be happening in hardware. Thus, it is expected the number of redirected packets to be zero or very low. The proper way to tell if WCCP is redirecting traffic to your WAE is to issue the command "show wccp gre" on the WAE and look for the line "transparent non-GRE packets received."
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
In the Previous articles of ACI Automation, we are using Postman/Newman as the Rest API tool to automate the ACI Configuration.
In this article I’m going to discuss on usin...
One of the first steps in building your ACI Fabric is to go through Fabric Discovery. While Fabric Discovery is usually a straightforward process, there are various issues that may prevent you from discovering an ACI switch. This article wil...