Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem with inline module on WAE device "Disable bypass mode is on"

Hi all,

I have run into a problem with a new WAE 674 appliance with integrated inline adapter.

I did a basic setup and everything seemed to work properly until we tested the

mechanical bypass of the inline card ( power failure). Unfortunately this feature does

not work on this new WAE/inline card. I compared the configuration with some other,

already installed WAEs, and did not find any misconfiguration. I have found one

difference, though - when i do a "show interface inlinegroup 1/0" a get a line which

is:  "Disable bypass mode is on".

On all other WAEs with inline interfaces we have this line is: "Disable bypass mode is off"

Does this mean that mechanical bypass is administratively turned off ? And if so, how can this

turned on again ?

Thank you for your kind help

With kind regards

Andreas

520
Views
0
Helpful
0
Replies