Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

replace inlinecard optimisation with WCCP

The WAAS device at this site is working fine and optimising the traffic using inlinecard . Due to the business requirements, we have to disable the Inlinecard optimisation and enable WCCP. We want to make sure that , we can do this activity  with loosing remote access to the device.

We are planning to assign a temporary IP address to portchannel interface and then assign the physical interfaces to it,removing the IPadd assinged to Gig 1/0. Once, this activity is completed we can change the correct IP to port-channel using WAAS CM. But, I am afraid that we may lose remote access to the device while changeing the primary-interface from Gi 1/0 to port-channel . Is there any other way( via WAAS CM ) to configure this with out loosing the remote access to the device.

Unfortunately, we cannot telnet into the device using the switch as it is not in our control.

Please advice.

Expected config on the device:

 

primary-interface PortChannel 1
!
interface PortChannel 1
ip address <IP add> <subnetmask>
exit
!
interface GigabitEthernet 1/0

channel-group 1
exit
interface GigabitEthernet 2/0

channel-group 1
exit
!
ip default-gateway <IP add>

Existing config on the device:

 

primary-interface GigabitEthernet 1/0
!
interface GigabitEthernet 1/0

ip address <IP add > <subnetmask>
exit
interface GigabitEthernet 2/0
shutdown
exit
!
interface InlineGroup 1/0
inline vlan all
exit
interface InlineGroup 1/1
inline vlan all
exit
!
ip default-gateway <IP add>
Everyone's tags (2)
286
Views
0
Helpful
0
Replies