Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

single WAE setup in HSRP environment

Hi,

I have this particular setup with the WAE connected to the standby router(not inline) and the traffic comes in from the active router.

The active and standby router are interconnected and using iBGP.

Will the WAE actually sync with the active router connecting from standby router with the normal redirect commands?

Do I need to do something so that the redirected traffic from router 1 goes to the WAE connected to r2?

router 1

ip wccp 61

ip wccp 62

LAN

ip wccp 61 redirect in

WAN

ip wccp 62 redirect in

router 2

LAN

ip wccp 61 redirect in

WAN

ip wccp 62 redirect in

WAE connected LAN

ip wccp redirect exclude in

WAE

wccp router-list x r1 ip

wccp router-list x r2 ip

wccp tcp-promiscuous router-list-num x

wccp version 2

egress-method negotiated-return intercept-method wccp

Everyone's tags (2)
2 REPLIES
Cisco Employee

single WAE setup in HSRP environment

Hi,

The WAE will attempt to pair with both routers configured in the router list, so your setup should work fine with the configuration you are proposing.

Regards

Daniel

New Member

single WAE setup in HSRP environment

One thing about this config is you will to put both routers on the same list in the WAE.

wccp router-list 1 (r1-ip) (r2-ip)

!

wccp tcp-promiscuous router-list-num 1

This will do what you want it to do.

459
Views
0
Helpful
2
Replies
CreatePlease to create content