Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Software upgrade procedures for WAAS SM-SRE?

I need to upgrade a few ISR G2 router SM-SRE modules from WAAS 4.2.3 to 4.4.1. I found a SRE installation document but it doesn't have the detailed steps. I have come up with the following steps. Can someone verify if I'm missing anything?

1. Download waas-sre-installer-4.4.1.12-k9.zip to FTP server, for example 10.10.10.10

2. Unzip the file and save unzipped file in the same directory, for example WAAS_Image

3. From the router, copy and install the new image:

Router# service-module sm 1/0 install url ftp://username:passwd@10.10.10.10/WAAS_Image/waas-sre-installer-4.4.1.12-k9.bin

4. From the router, reload the module

Router# service-module sm 1/0 reload

Thanks a lot

1 ACCEPTED SOLUTION

Accepted Solutions

Software upgrade procedures for WAAS SM-SRE?

Correct doing a copy ftp install will just get the software downloaded and ready for install on reboot.  There should be no affect on normal operations.

Correct coy ftp disk will download a file to the local disk of the WAE.

-Mike

3 REPLIES

Software upgrade procedures for WAAS SM-SRE?

Hi,

If your SRE is currently running WAAS there is no need to install WAAS via the install package as you have outlined. The process you have outlined is for installing WAAS on an SRE for the first time (e.g. a blank SRE module).

Upgrading WAAS on SRE is the same as you would for any other WAAS appliance.  Either create the job in the CM and push it to the SRE or you can do the install via CLI of the WAAS device "copy ftp install "

See the upgrade section of the configuration guide here:

http://www.cisco.com/en/US/docs/app_ntwk_services/waas/waas/v441/configuration/guide/maint.html#wp1101565

Regards,

Mike Korenbaum

Cisco Data Center PDI Help Desk

http://www.cisco.com/go/pdihelpdesk

New Member

Software upgrade procedures for WAAS SM-SRE?

Thanks a lot. If I use "copy ftp install" from a WAE, the new image will be downloaded and installed without reloading. If I do this during normal hours, and wait till late night to reload, it should not affect the WAE running on old software during the interval. Is it correct?

If I only want to download new image to WAE without installing, is it "copy ftp disk" to copy to the WAE root directory?

Thanks again

Software upgrade procedures for WAAS SM-SRE?

Correct doing a copy ftp install will just get the software downloaded and ready for install on reboot.  There should be no affect on normal operations.

Correct coy ftp disk will download a file to the local disk of the WAE.

-Mike

1291
Views
6
Helpful
3
Replies