01-18-2012 06:09 AM
How do I set the virtual blade to autostart. After MS updates we did a reboot, and the server did not come back up until I went into the Central Manager and selected "Start Virtual Blade". Is there a setting in there to make sure the blade is set to autostart?
Solved! Go to Solution.
01-18-2012 06:16 AM
Hi,
Can you check and see if Auto Start is checked for this Virtual
blade configuration and it is set to boot from disk rather cdrom? See below
link
http://www.cisco.com/en/US/docs/app_ntwk_services/waas/waas/v411/configurati
on/guide/virtual.html#wp1051532
Ahsan
01-18-2012 06:16 AM
Hi,
Can you check and see if Auto Start is checked for this Virtual
blade configuration and it is set to boot from disk rather cdrom? See below
link
http://www.cisco.com/en/US/docs/app_ntwk_services/waas/waas/v411/configurati
on/guide/virtual.html#wp1051532
Ahsan
01-18-2012 07:27 AM
Yes, it is checked now. Thank you! I knew it was right under my nose.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: