Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Virtual Blade Not set to Autostart

How do I set the virtual blade to autostart.  After MS updates we did a reboot, and the server did not come back up until I went into the Central Manager and selected "Start Virtual Blade".  Is there a setting in there to make sure the blade is set to autostart?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Virtual Blade Not set to Autostart

Hi,

Can you check and see if Auto Start is checked for this Virtual

blade configuration and it is set to boot from disk rather cdrom? See below

link

http://www.cisco.com/en/US/docs/app_ntwk_services/waas/waas/v411/configurati

on/guide/virtual.html#wp1051532

Ahsan

2 REPLIES
Cisco Employee

Re: Virtual Blade Not set to Autostart

Hi,

Can you check and see if Auto Start is checked for this Virtual

blade configuration and it is set to boot from disk rather cdrom? See below

link

http://www.cisco.com/en/US/docs/app_ntwk_services/waas/waas/v411/configurati

on/guide/virtual.html#wp1051532

Ahsan

New Member

Re: Virtual Blade Not set to Autostart

Yes, it is checked now. Thank you!  I knew it was right under my nose.

308
Views
0
Helpful
2
Replies
CreatePlease login to create content