Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WAAS 7341 HA Deployment

Hello,

I have a couple of questions here for my WAAS HA implementation.

I've attached the topology so as we can better understand.

1 - What cables should i use between Firewall ( ASA 5500 ) and WAAS on the LAN side and on the WAN side to the Switch ( WS-C6509-E ) using inline deployment so as if i put the WAAS under passthrough ( Shutdown ) mode it works ?

2 - In order to have High Availability using 2 x WAAS 7341 and inline card, i need to connect the WAAS devices like the attached file "WAAS HA Inline Cabling.vsd" ?

3 - I've configured the inlinegroup 1/0 and 1/1 of each WAAS with failover timeout 3 so how can i force it to failover through CLI ? if possible.

3 - Do i need to configure direct mode on a WAAS that is after the firewall ? We don't have WAAS on the remote sites. Check attached file "Topology.vsd"

Thanks a lot for any help.

1 REPLY
Cisco Employee

Re: WAAS 7341 HA Deployment

I'll answer this as part of the Ask The Expert going on right now.

Thanks,

Zach

328
Views
0
Helpful
1
Replies