WAAS and Netflow, traffic reports are inflated unpredictably
Not sure if anybody has any luck getting Netflow to report correctly when WAAS is in a picture. We have about 30 sites deployed with WAAS in out of line configuration and every single one of them incorrectly report Netflow traffic to our NetQoS Reporter Analyzer product. Typically the traffic throughput seems to be inflated several times higher. We tried every which way to alter the netflow configuration in the router including Egress Netflow but the traffic is still showing higher than actual traffic coming out of a port. In one site, even the "show interface" command on the router shows 5-minute rate of 16Mbps on a 6Mbps Mulitlink circuit.
VMware Trunk Port Group is supported from ACI version 2.1
VMM integration must be configured properly
ASA device package must be uploaded to APIC
ASAv version must be compatible with ACI and device package version
In the Previous articles of ACI Automation, we are using Postman/Newman as the Rest API tool to automate the ACI Configuration.
In this article I’m going to discuss on usin...
One of the first steps in building your ACI Fabric is to go through Fabric Discovery. While Fabric Discovery is usually a straightforward process, there are various issues that may prevent you from discovering an ACI switch. This article wil...