We are about deploying WAAS for a client , we notice the Cisco switch 6506 we plan to config WCCP ver 2, the switch is running Cat IOS Version McpSW: 5.5(1): we notice it support WCCP ver 2, but on the interface it can only support ip wccp 6x redirect out only. What can we do to deploy WAAS Device with WCCP using above mentioned switch
When using a 6500 in Hybrid mode we recommend using the following minimum CAT OS and IOS version and requirements.
Also, we would highly encourage you to use L2-redirect and Mask assignment as the redirect and assignment method configured on your WAE(s) which would require the WAE(s) to be layer 2 adjacent to the 6500.
Lastly, you should use redirect in statements only (typically 61 redirect in on the LAN facing L3 interface(s) and 62 redirect in on the WAN facing L3 interface(s)).
By using L2-redirect, Mask assignment, and only redirect in statements, all wccp redirect traffic will be handled in hardware on the 6500. Any deviation from this will cause increased CPU utilization on the 6500 and may impact performance.
Introduction This article will help you understand the steps on how to
download the UCS licenses from the Cisco Systems website and then
installing it on the UCS. The redacted (blue lines) just covers up
certain numbers for privacy please do not take them...
Introduction This article will help you understand and educate the
customer on how to clear their "expired licenses"
(license-graceperiod-expired) from their UCS-M. If a customer just
purchased a license and needs a step by step guide on how to download
Introduction Prepositioning is a powerful tools on the WAAS platform but
it is not always easy to figure out why your jobs are failing when
trying to retrieve the files.Here is a method that should help you to
figure out the reason why they are not succes...