We have eazy vpn setup from almost 50 branches to our HO . Now we are going to introduce WAAS , we have few servers connected in the DMZ zone of the ASA ((ASA is directly connected to ACE(6504-E ACE bundle), as shown in the diag)) here ACE is configured as bridge mode . Few servers are connected in the inside of our core network .( As mentioned in the diag ) . I want to do acceleration on both inside and outside servers. where should place WAAS in this scenario ?
Considering your traffic pattern with the ASAs, I'm not sure there is a single interception point without rearchitecutre. However, I would consider putting WAEs in front of your server VLAN as well as on your internal network. There are ASA inspection commands (Inspect WAAS) for WAAS with the appropriate code levels (7.2.3 release and higher, as well as v8.0.3 and higher).
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...