I was ask to disable the virtual blade features in our WAVE-694-K9 (running universal-k9 Software Release 4.4.5d). I try issue the command
1. virtual-blade 1 stop in exec mode ( I did for all 1-6)
2. no virtual-blade 1 in global config mode ( I did for all 1-6)
Commands are taken by device. After i did the restart the devcie when i check the config ,the command "virtual-blade enable" still appeared in show run output. Could you please advise me how we can disable this feature from the box ?
It seems you cannot undo(disable VB once you enable it) unless you reinstall the WAAS software using recovery CD. Once virtualization is enabled, system resources are reserved and are not available for your WAAS system even if VB is not active.
Please visit section: "Preparing to use Virtual Blades".
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...