Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Waas DUP! ping

I just installed waas in version 4.2.1 and got a weird ping result. On the core wae  I enabled the management interface as gig1/0 (10.0.0.1) and the gigi 2/0 just for wccp with the router (192.168.0.1) and the default gateway on the same subnet as the management interface. When I do a ping to the management interface of the waas from a remote location I get this duplicate pings, when I perform a trace route this does not happen. Is this an expected behavior?

Remote_waas#ping 10.0.0.1

PING 10.0.0.1 (10.0.0.1) 56(84) bytes of data.

64 bytes from 10.0.0.1: icmp_seq=1 ttl=58 time=18.8 ms

64 bytes from 10.0.0.1: icmp_seq=1 ttl=58 time=20.9 ms (DUP!)

64 bytes from 10.0.0.1: icmp_seq=2 ttl=58 time=17.9 ms

64 bytes from 10.0.0.1: icmp_seq=2 ttl=58 time=19.6 ms (DUP!)

--- 10.0.0.1 ping statistics ---

2 packets transmitted, 2 received, +2 duplicates, 0% packet loss, time 999ms

rtt min/avg/max/mdev = 17.914/19.329/20.973/1.127 ms

2 REPLIES
Cisco Employee

Re: Waas DUP! ping

You do not mention what the remote-wae is - does it have an in-line card?  Do you see the same behavior from a PC behind  the remote-wae?

Michael

New Member

Re: Waas DUP! ping

The remote wae is using Wccp (I do not have an inline card there but I am using just one interface for Management and wccp). If I ping from the remote PC I do not see this behavior.

874
Views
0
Helpful
2
Replies
CreatePlease to create content