cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1686
Views
0
Helpful
3
Replies

Waas Licencing

sprocket10
Level 2
Level 2

 

We have 4 819 routers that come licenced for was express. The first unit is about 6 months old and was is licenced and ready, the 3 new units show was as expired and don't show any licence. Is there a command to enable the was?

1 Accepted Solution

Accepted Solutions

Hi,

NOTE: Below is when you had purchased the license and have PAK file. If you don't have this, please contact CISCO LICENSING team and they will generate one for you.

Obtain a license:

A PAK will be provided after you purchase the WAAS Express license. At the time of placing an order, you can choose the PAK to be mailed to you or electronically mailed. Collect the output of show license udi command , Note the product ID (PID) and serial number (SN).

Figure 8. Output

Router#show license udi
Device# PIDSN UDI
-----------------------------------------------------------------------------
*0 CISCO2911/K9FHH122500AZCISCO2911/K9:FHH122500AZ

Visit the Cisco License Activation Portal ( http://www.cisco.com/go/license) and enter the PAK, product ID, and serial number information, along with your contact email address. A license file will be generated and emailed to you.

Hope this helps!

Regards,

Kanwal

View solution in original post

3 Replies 3

Kanwaljeet Singh
Cisco Employee
Cisco Employee

Hi,

Please go to the below link and visit sections:

6.1 Checking for WAAS Express License File

6.2 How to Obtain a License File

6.3 Install WAAS Express License

http://www.cisco.com/c/en/us/products/collateral/routers/wide-area-application-services-waas-express/deployment_guide_c07-713403.html#wp9000280

Once the license is installed you can go ahead and enable WAAS express.

Hope this helps.

Regards,

Kanwal

show license detail WAAS_Express
% Error: No license for WAAS_Express found - License feature not found

 

One of the devices in question is the 819HG 4G unit which came with the license envelope, but no codes on the sheet inside. The 819HG units are meant to come with waas express and our first unit last year did and was preinstalled.

Hi,

NOTE: Below is when you had purchased the license and have PAK file. If you don't have this, please contact CISCO LICENSING team and they will generate one for you.

Obtain a license:

A PAK will be provided after you purchase the WAAS Express license. At the time of placing an order, you can choose the PAK to be mailed to you or electronically mailed. Collect the output of show license udi command , Note the product ID (PID) and serial number (SN).

Figure 8. Output

Router#show license udi
Device# PIDSN UDI
-----------------------------------------------------------------------------
*0 CISCO2911/K9FHH122500AZCISCO2911/K9:FHH122500AZ

Visit the Cisco License Activation Portal ( http://www.cisco.com/go/license) and enter the PAK, product ID, and serial number information, along with your contact email address. A license file will be generated and emailed to you.

Hope this helps!

Regards,

Kanwal

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: