I have a question on how the DeltaCache on the server is used. Currently we have a handful of clients that have been using the WAAS Mobile for a week or so and when I look at the location i've set for the DeltaCache E:\DeltaCache I see nothing in here.
I check out each client and can see they are using some some of their own local workstation deltacache but nothing is on the server. I find that a bit odd however everything looks to be working just fine and the connections are optimized for CIFS, ACAD, and other processes.
If the Delta Cache on your server is not populated, then it is possible that no compression is occuring. Other optimizations will still occur leading you to believe that all is OK. I have seen this when there is not enough disk space to create a server cache. Another thought is that you may have changed the delta cache location and not applied the settings (a requirement in release 3.5). Changing the location also requires a reboot of the server.
If none of this applies, I suggest you send a server system report to you Cisco support SE and we will take a look.
Thanks for the reply. We've got more then enough disk space. 450GB is allocated. We did change the delta cache location from the original location and I'm pretty sure we applied that and restarted. However I will give it another try.
Thanks for the tips, i'll let you know if that works
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...