Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WAAS module doesn't take the ip address

                   Dear all,

I have the folowing setup for a new installation.

c2900-universalk9-mz.SPA.150-1.M2.bin--CISCO2911/K9

nme-wae-502-4.1.5c.17---WAAS module

On the router I have done the following configuration.

interface Integrated-Service-Engine1/0

ip address 10.52.5.253 255.255.255.252

ip wccp redirect exclude in

service-module ip address 10.52.5.254 255.255.255.252 <---THIS DOEN'T TAKE..WHAT IS THE REASON

  service-module ip default-gateway 10.52.5.253

Since "service-module ip address 10.52.5.254 255.255.255.252" command doen't take I cannot access the module.To configure the module I should be bale to acces the module by command of "Router#service-module integrated-Service-Engine 1/0 session"(Pls correct me if i am wrong)

I am getting message "% Connection refused by remote hos"

My idea is to configure thw waas module and connct to the CM.Pls advice me how to do it if the above procedure is not correct.

Thanks

389
Views
0
Helpful
0
Replies