Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WAE-512 disk failure

A WAAS withe dual disk DISK-SATA2-250GB. One disk failed and I want to replace the drive.

The question is, once I swap the drives will the new drive get rebuilt automatically?

Thanks

  • Wide Area Application Services (WAAS)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: WAE-512 disk failure

Follow the following instructions on cisco.com

http://www.cisco.com/en/US/docs/app_ntwk_services/waas/waas/v413/configuration/guide/maint.html#wp1139597

Also remember, the WAE-512 doesn't have hot swap cabability, so you should power off the device after you have performed the "disk disk-name diskxx shutdown" command before pulling the faulty drive.

Hope that helps,

Dan

1 REPLY
Cisco Employee

Re: WAE-512 disk failure

Follow the following instructions on cisco.com

http://www.cisco.com/en/US/docs/app_ntwk_services/waas/waas/v413/configuration/guide/maint.html#wp1139597

Also remember, the WAE-512 doesn't have hot swap cabability, so you should power off the device after you have performed the "disk disk-name diskxx shutdown" command before pulling the faulty drive.

Hope that helps,

Dan

424
Views
0
Helpful
1
Replies
This widget could not be displayed.