04-24-2009 07:23 AM
A WAAS withe dual disk DISK-SATA2-250GB. One disk failed and I want to replace the drive.
The question is, once I swap the drives will the new drive get rebuilt automatically?
Thanks
Solved! Go to Solution.
04-24-2009 12:50 PM
Follow the following instructions on cisco.com
Also remember, the WAE-512 doesn't have hot swap cabability, so you should power off the device after you have performed the "disk disk-name diskxx shutdown" command before pulling the faulty drive.
Hope that helps,
Dan
04-24-2009 12:50 PM
Follow the following instructions on cisco.com
Also remember, the WAE-512 doesn't have hot swap cabability, so you should power off the device after you have performed the "disk disk-name diskxx shutdown" command before pulling the faulty drive.
Hope that helps,
Dan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: