Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

WAE-612 does't recognise disks in 0/0

I purchased a WAE-612 with ACNS software, but it doesn't recognize any disk i put in slot 0, box0.

In fact, the bios boot gives me:

Slot Box Dev SAS Address Vendor Model Rev Size

-----------------------------------------------------------------------

0 00 0 FFFFFFFFFFFFFFFF Disk Error

1 01 1 500000E01F667231 IBM-ESXSMBA3300RC SA05 279.39 GB

7F 01 2 5005076C05C314CE IBM SAS SES-2 DEVICE 1.11

if i swap slot 1 disk with slot 0 -> the same. it doesn't seem to recognize any disk in slot 0.

DOA replacement ?

PS. I tried option 7 using recoevery cd , didn't work

i tried "disk recover" command, didn't work

2 REPLIES
Cisco Employee

Re: WAE-612 does't recognise disks in 0/0

You could look internally to make sure the cables are secure. I would then recommend you RMA the unit, the controller or internal connections may be faulty.

Hope that helps,

Dan

Re: WAE-612 does't recognise disks in 0/0

If you have done the troubleshooting to show the problem follows the slot and not the disks, you will want to proceed with a DOA RMA.

- Dan

215
Views
0
Helpful
2
Replies
CreatePlease login to create content