Have a WAE-674 that I am trying to upgrade from 4GB to 8GB.
I followed the Cisco Wide Area Application Engine 7341, 7371 and 674 Hardware Installation Guide for installing memory in a WAE-674.
We installed our 2GB DIMMs into DIMM slots 7 and 10 per the guide.
I repartition the disks using the "disk delete-data-partitions" command and issued a reload.
After the WAE reloads, I only see 4GBs of memory and only DIMMs 7 and 10 appear.
Am I missing a configuration piece on the WAE for 4GB to 8GB?
Below is some snippets from show memory and show hardware.
Total memory : 3909612 KB Total free memory : 2005044 KB Total buffer memory : 141272 KB Total cached memory : 757136 KB Total swap : 8388360 KB Total free swap : 8388360 KB
Power Supply 2 Status : Presence detected Power Supply 1 Status : Presence detected CPU 0 is GenuineIntel Intel(R) Xeon(R) CPU E5335 @ 2.00GHz (rev 15) running at 1994MHz. CPU 1 is GenuineIntel Intel(R) Xeon(R) CPU E5335 @ 2.00GHz (rev 15) running at 1994MHz. CPU 2 is GenuineIntel Intel(R) Xeon(R) CPU E5335 @ 2.00GHz (rev 15) running at 1994MHz. CPU 3 is GenuineIntel Intel(R) Xeon(R) CPU E5335 @ 2.00GHz (rev 15) running at 1994MHz. Total 4 CPUs. 4096 Mbytes of Physical memory. 128 MBytes of flash memory 1 CD ROM drive (Vendor MATSHITA Model UJDA782 DVD/CDRW) 2 GigabitEthernet interfaces 2 InlineGroup interfaces. 1 Console interface
The unmanaged mode is also known as Network only switching, which is introduced in Brazos release. It adds the flexibility for customer to use only network automation for service appliance.
If a device is configured a...
Usually, we can access ESXi Shell by pressing Alt+F1 from ESXi DCUI (Direct Console User Interface).
But on HyperFlex system, it just shows black window.
This is expected behavior because HyperFlex redirects ESXi Shell output to SoL...
Configuring an Export Policy Using the GUI
This procedure explains how to configure an Export policy using the APIC GUI. Follow these steps to trigger a backup of your data:
On the menu bar, choose Admi...