I have a brand new WAE512 with no inline card plugged in. During bootup, it says "operating system not found". I then tried a 4.0.9 Recovery CD. At the Installer Menu, I selected "install image from cdrom". But the message came up as "no Flash detected . . .".
Does it mean the WAE512 box does not have Flash installed? I'm guessing every box is supposed to have Flash installed out of factory. How can I confirm if the box has Flash or not?
Pull the top and right above the hard drives, where there would be a floppy drive in the old days, there should be a flash card inserted into a reader on a IDE cable. Sometimes it's loose inside the reader or has fallen out. See if you find one floating around in the chassis.
Why do you need native HA: The native HA feature allows two Cisco DCNM
appliances to run as active and standby applications, with their
embedded databases synchronized in real time. Therefore, when the active
DCNM is not functioning, the standby DCNM will...
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...