Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WCCP and use of Inbound/outbound ACLs

Hi Guys,

I was looking for some documentation regarding the flow of packet processing on a given interface, namely with use of WCCP.

I have a design requirement to enable WCCP on interfaces with inbound and outbound security ACLs, I was wondering what is the order in which a packet gets processed on an interface, does it get redirected before security inbound ACL is processed? And going outbound?

Would I need to add the Cache engine IP to the security ACLs?

I can't disable these ACLs, any gotcha's with using L2 redirection?

Thanks

  • Wide Area Application Services (WAAS)
Everyone's tags (2)
1 REPLY
New Member

WCCP and use of Inbound/outbound ACLs

FYI I had found this:

http://www.cisco.com/en/US/prod/collateral/routers/ps9343/white_paper_c11_502351.html

Inside to outside:

1. decryption

2. input ACL

3. inspect

4. routing

5. WCCP

6. Network Address Translation (NAT) inside to outside

7. crypto (check map and mark for encryption)

8. output ACL

9. inspect

Outside to inside:

1. decryption

2. input ACL

3. inspect

4. NAT outside to inside

5. WCCP

6. routing

7. crypto (check map and mark for encryption)

8. output ACL

9. inspect

568
Views
0
Helpful
1
Replies