when trying to download 4.1.5f WAE stays in pending mode
in the process of upgradinf from 4.13b to 4.1.5f
, CM is at 4.1.5f, when start a software upgrade most of the WAEs upgrade ok, but a couple stay in pending mode and when I look at the syslog i see the following message:
2010 May 5 21:54:54 BATWAD01 java: %WAAS-CMS-4-700002: ce(DataFeedPoll): java.l ang.IllegalStateException: Managed store key does not exists, which is needed to process SslCertificateKey objects. Rejecting updates from CM: java.lang.Illegal StateException: Managed store key does not exists, which is needed to process Ss lCertificateKey objects. Rejecting updates from CM at com.cisco.unicorn.dir ector.DataFeedAgent.storeUpdateInternal(DataFeedAgent.java:251) at com.c isco.unicorn.server.ADataFeedAgent.storeUpdate(ADataFeedAgent.java:755) a t com.cisco.unicorn.server.ADataFeedAgent.onUpdate(ADataFeedAgent.java:510) a t com.cisco.unicorn.server.ADataFeedAgent.getUpdatesFromCurrentCdm(ADataFeedAgen t.java:1230) at com.cisco.unicorn.server.ADataFeedAgent.getUpdates(ADataFeedA gent.java:956) at com.cisco.unicorn.director.DataFeedAgent.getUpdates(DataFeedA gent.java:1248) at com.cisco.unicorn.server.ADataFeedAgent.runImpl(AData FeedAgent.java:678) at com.cisco.unicorn.server.AModule.run(AModule.java:177 ) at java.lang.Thread.ru
I do not use SSL so not have any keys
How do I download the new code and get rid of thepending message
Re: when trying to download 4.1.5f WAE stays in pending mode
Do you have any alarms in the box. I faced the same issue and it had an SSLAO alarm. I downgraded to 4.1.3b, disabled SSLAO and upgraded 4.1.5f .It worked. I am not sure thats a perfect solution, but it worked for me
This document will provide screenshots to outline the steps to setup
TACACS+ configuration to ACI and also the configuration required on
Cisco ACS server. Please find the official Cisco guide for configuring
TACACS+ Authentication to ACI:
Is it supported or NOT supported? It's a frequently asked question.
Before APIC, release 2.3(1f), transit routing was not supported within a
single L3Out profile. In APIC, release 2.3(1f) and later, you can
configure transit routing with a single L3Out pr...
Cisco Documents are usually accurate, but when it came to the document
on Cisco APIC Signature-Based Transactions it was slightly off the mark.
This document is for those novices to API like me who cant seem to
figure out how to go about performing signat...