Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

1142 Autonomous Cli commands for 40MhZ bonding DFS

Does anyone know of a command that I can issue from the CLI that will inform me of the two channels that the AP is using to bond for the 40MhZ width when I select DFS.  I know I can choose either above or below.  Does it just use the next channel ?  So if DFS selects 36 does it just automatically the next channel up if I have 40Mhz Above selected?

I have autonomous 1142's and I would like to know what the 2nd Channel.  Keep in mind these are Autonomous AP's.

Also would like to know a CLI command to find out what the channel currently is for either radio if DFS is selected?

Any docs on CLI commands for the 1142 would be appreciated.

Thank you!

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: 1142 Autonomous Cli commands for 40MhZ bonding DFS

Yes, if you configure 40MHz above it will just use the next channel.  Same with 40MHz below, it will just use the next channel down.

To see which channel the AP is currently using you can look under "show controller d1"

2 REPLIES
Gold

Re: 1142 Autonomous Cli commands for 40MhZ bonding DFS

Yes, if you configure 40MHz above it will just use the next channel.  Same with 40MHz below, it will just use the next channel down.

To see which channel the AP is currently using you can look under "show controller d1"

New Member

Re: 1142 Autonomous Cli commands for 40MhZ bonding DFS

dancampb

thank you for the reply - I also noticed now that If you have it configured for 40-below and DFS selects channel 36 bumps it up to 40-Above.

Again thank you for your reply.

Rudy

1608
Views
0
Helpful
2
Replies
CreatePlease to create content