Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

4402 LAN Controller and 44 AP Point with CUCM 7.1

First time going to configure 4402 LAN Controller with 44 AP with 7921 wireless IP Phone, Please light me with document and info to configure 4402 lan controller with Access point.

Just connecting Controller and AP in switch both will get registered, I have two LAN Controller for redundancy [ how to configure redundancy in controller ].

For layer 3 roaming what are the basic steps I should configure in controller and AP.

2 REPLIES
Gold

Re: 4402 LAN Controller and 44 AP Point with CUCM 7.1

Here's a link to the doc that outlines how to configured the controller to best support a 7921:

http://www.cisco.com/en/US/docs/voice_ip_comm/cuipph/7921g/6_0/english/deployment/guide/7921dply.pdf

For redundancy you will want to have the controller in the same mobility group:

http://www.cisco.com/en/US/docs/voice_ip_comm/cuipph/7921g/6_0/english/deployment/guide/7921dply.pdf

Having them in the same mobility group will also take care of any roaming between controllers.

Re: 4402 LAN Controller and 44 AP Point with CUCM 7.1

In Switch If I connect controller and Access point it will get register by itself or we want to enter the Access poin to controller one by one, what are the steps should be configured in Controller and Access point for layer 3 roaming.

356
Views
0
Helpful
2
Replies