7920 roaming between two WLCs

[elkono200]

hi,

- i have two WLCs 4404 and 4402 in the same mobility group and all connections seem to be ok.

- one ssid for voip.

- two 7920 phones

when i roam between the WLCs i will lose the connection.

What should i configure on the WLC??

thx

[migilles]

Are you doing L3 mobility?

If so, would configure the voice ssid for the same VLAN on both controllers to see if that works or not.

Of course for mobility group setup, need the mac and IP configured on each contoller in that mobility group.

Ensure that 3.02 is loaded on the 7920 phones.

Would recommend 4.0.217.0 or later for the controller version.

Refer to WLAN SRND for more info.

http://www.cisco.com/univercd/cc/td/doc/solution/emblty30.pdf

[elkono200]

General

802.3x Flow Control Mode

LWAPP Transport Mode

LAG Mode on next reboot

Ethernet Multicast Mode

Aggressive Load Balancing

Peer to Peer Blocking Mode

Over The Air Provisioning of AP

AP Fallback

Apple Talk Bridging

Fast SSID change

Default Mobility Domain Name

RF-Network Name

both WLCs are in the same mobility group.

Firmware on 7920: 7920.4.0-03-00

Firmware on WLCs: 4.0.217.0

thx

[migilles]

Would want to use 3.02 for 7920 as there were some key fixes in 3.01 to interoperate successfully with 4.0 controller version.