Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

7921 using wpa2 with EAP Fast

I have some 7921 phones. I am trying to connect them using a 4404 wlc on firmware 4.1.181.0

I can connect using wep, but it wont authenticate using wpa2. I have tested the ssid with my laptop and it works, but with the phone it isnt even hitting the radius server.

Any suggestions?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: 7921 using wpa2 with EAP Fast

Will want to use version 1.03.

Also for WPA2, will need to set the phone to either EAP-FAST or AKM mode. AKM mode will use LEAP for 802.1x. EAP-TLS and PEAP are not supported currently on the Cisco 7921G.

If using EAP-FAST, may want to increase the 802.1x timeout on the controller. See http://www.cisco.com/univercd/cc/td/doc/product/voice/c_ipphon/english/wip7921/relnote/rn7921_3.htm#wp161964.

3 REPLIES
Community Member

Re: 7921 using wpa2 with EAP Fast

also on the phone:

App Load ID CP7921G-1.0.2.LOADS

Boot Load ID BL-P203-6065E201

WLAN Driver id is 5.0.0.96

WLAN Firmware ID 4.1.0.80

Cisco Employee

Re: 7921 using wpa2 with EAP Fast

Will want to use version 1.03.

Also for WPA2, will need to set the phone to either EAP-FAST or AKM mode. AKM mode will use LEAP for 802.1x. EAP-TLS and PEAP are not supported currently on the Cisco 7921G.

If using EAP-FAST, may want to increase the 802.1x timeout on the controller. See http://www.cisco.com/univercd/cc/td/doc/product/voice/c_ipphon/english/wip7921/relnote/rn7921_3.htm#wp161964.

Community Member

Re: 7921 using wpa2 with EAP Fast

Thanks,

That resolved all my issues!

350
Views
0
Helpful
3
Replies
CreatePlease to create content