AIR-CT2504-50-K9 with out DHCP Static config

[VIVIDHA IT SOLUTIONS INDIA PVT LTD]

We have AIR-CT2504-50-K9 and AIR-CAP1602I-TK910 30 devices we want config trough controller to AP with out DHCP

[Rasika Nayanajith]

Hi Rao,

What do you mean by "we want config trough controller to AP with out DHCP" ? Does this mean you want AP to discover WLC without using DHCP?

You can use DNS instead.

Anyway please clarify your question to provide you a good response

HTH

Rasika

[VIVIDHA IT SOLUTIONS INDIA PVT LTD]

Hi,

We have AIR-CT2504-50-K9 and AIR-CAP1602I-TK910 30 devices we dont have DHCP Server

with out DHCP how to configure static ip on AP and end users.

[Rasika Nayanajith]

You can configure cisco IOS device (switch or router) as your DHCP server, you do not required seperate DHCP server to do this.

HTH

Rasika

[kaaftab]

you can use any opens source OS as DHCP server like centOS etc or as mentioned use router or switch for the same.
 

[Saravanan Lakshmanan]

#Yes, you can use internal dhcp server on WLC-2500 to lease IPs to the connected APs using L2/Broadcast, once AP gets an ip then you can make those IPs as static on those APs via check box from AP's general tab after it joins the WLC.

#Remeber, WLC dhcp doesn't support option 43, if the AP and WLC management are L3, be sure to use ip-helper at L3 for wlc discovery. Also, don't think AP may receive ip from WLC dhcp server when it is L3 and dhcp proxy is used instead of broadcast.