Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

AIR-LAP-1231G-A-K9 Problem with light weight commands on access point

Hi All

I got a issue with AP 1231g it wont take any Light weight commands after I conected to the controller any help is good....

I reset the item too default same issue....  in about 10 AP.

thanks guys

sincerely

JC

4 REPLIES

Re: AIR-LAP-1231G-A-K9 Problem with light weight commands on acc

What commands are you attempting to use ?

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
Hall of Fame Super Gold

Re: AIR-LAP-1231G-A-K9 Problem with light weight commands on acc

If you are using 4.X and 5.X firmware, there are a lot of LWAP commands that are disabled.

Re: AIR-LAP-1231G-A-K9 Problem with light weight commands on acc

Thanks  I will ask more details,   I already ask that question to the customer.

but no answer back.....yet...

thanks a lot for you time too....

keep in touch.

cmartin_39

Re: AIR-LAP-1231G-A-K9 Problem with light weight commands on acc

There is little need to access the AP in lwapp mode unless you are manually priming or troubleshooting ...

__________________________________________________________________________________________ "Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin ___________________________________________________________
386
Views
0
Helpful
4
Replies
CreatePlease to create content