Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Aironet 1040 Serien, Can limit users in SSID?

Some time ago have this question, and now is a problem, because a ssid have more users than workstations!

Anyone little help?¡

Everyone's tags (2)
2 ACCEPTED SOLUTIONS

Accepted Solutions
VIP Purple

Aironet 1040 Serien, Can limit users in SSID?

Do you have this AP in autonomous mode or Lightweight mode ???

If you this as Lightweight then you can restrict client per WLAN:

Here is the procedure:

http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a0080b9c159.shtml

If Autonomous then:

1st method: I am not sure about this method:

You can limit per SSID:

AP(config-ssid)# max-associations 20

The above example allows for 20 clients only to connect to the SSID. Change the number as you need.

2nd:

You can use mac filter.

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a0080c1e40b.shtml

Regards

Dont forget to rate helpful posts

Silver

You can use the command AP

You can use the command

 AP#max-association

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/12-2_13_JA/configuration/guide/i12213sc/s13ssid.html

to limit the users but do the capacity planning before limiting the users

 

3 REPLIES
VIP Purple

Aironet 1040 Serien, Can limit users in SSID?

Do you have this AP in autonomous mode or Lightweight mode ???

If you this as Lightweight then you can restrict client per WLAN:

Here is the procedure:

http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a0080b9c159.shtml

If Autonomous then:

1st method: I am not sure about this method:

You can limit per SSID:

AP(config-ssid)# max-associations 20

The above example allows for 20 clients only to connect to the SSID. Change the number as you need.

2nd:

You can use mac filter.

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a0080c1e40b.shtml

Regards

Dont forget to rate helpful posts

Silver

You can use the command AP

You can use the command

 AP#max-association

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/12-2_13_JA/configuration/guide/i12213sc/s13ssid.html

to limit the users but do the capacity planning before limiting the users

 

Cisco Employee

posted below answer :- The

posted below answer :-

 

The below link gives you idea about max allowed clients and also how to limit the maximum clients per WLAN.

You wil have to go to advanced tab of WLAN on WLC and enter the number of maximum clients that can be connected to the given WLAN.

 

http://www.cisco.com/image/gif/paws/113303/restrict-wlan-clients-00.pdf

470
Views
7
Helpful
3
Replies
CreatePlease login to create content