11-06-2001 12:00 PM - edited 07-04-2021 10:51 PM
Can you configure Bridge to work in a full duplex mode?
11-07-2001 05:08 AM
You can't have full duplex because both ends of a bridge link transmit on the same center frequency.
11-07-2001 07:29 AM
In short no. Another problem is with only antenna, the radio cannot transmit and receive at the same time on the same radio frequency.
11-08-2001 08:18 AM
Thanks alot..
11-12-2001 06:05 PM
Go with an FSO solution (much higher bandwidth, and you can have full duplex)
11-15-2001 10:04 AM
... or gang 2 or 3 350s together and load balance.
each one will still be half-duplex, but the potential for 2 or 3 to be tied up transmitting without receiving at the same time will be reduced.
Plus the aggregate pipe is 22 or 33Mbps nominal.
01-26-2003 07:31 AM
Do you know if you can deploy Netmeetings H.323 based VoIP over the 350 bridge??
Thanks,
Jon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide