Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Aironet 350 Bridge

Can you configure Bridge to work in a full duplex mode?

  • Wireless IP Voice and Video
6 REPLIES
New Member

Re: Aironet 350 Bridge

You can't have full duplex because both ends of a bridge link transmit on the same center frequency.

New Member

Re: Aironet 350 Bridge

In short no. Another problem is with only antenna, the radio cannot transmit and receive at the same time on the same radio frequency.

New Member

Re: Aironet 350 Bridge

Thanks alot..

New Member

Re: Aironet 350 Bridge

Go with an FSO solution (much higher bandwidth, and you can have full duplex)

New Member

Re: Aironet 350 Bridge

... or gang 2 or 3 350s together and load balance.

each one will still be half-duplex, but the potential for 2 or 3 to be tied up transmitting without receiving at the same time will be reduced.

Plus the aggregate pipe is 22 or 33Mbps nominal.

New Member

Re: Aironet 350 Bridge

Do you know if you can deploy Netmeetings H.323 based VoIP over the 350 bridge??

Thanks,

Jon

193
Views
0
Helpful
6
Replies