Welcome to Cisco Support Community. We would love to have your feedback.
For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.
I have a customer that wants a CCME solution with wireless 7920 IP Phones. For this I need the below -
HWIC-AP-G-E (the HWIC card)
CP-7920-ET-K9 (the IP Phone)
CP-PWR-7920-UK (the Power Supply)
CP-BATT-7920-STD (the Battery)
Currently these are not readily available in the UK without a long leadtime, my question is would there be any issues with getting these from the states and using in the UK?
I don't think there should any issues with this setup.
US phone will not have capabilities to use channels 12 or 13, plus can tranmsit up to 100mw, where transmission is limited to 50mw.