cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
514
Views
0
Helpful
1
Replies

AP Commands

tsmarcyes
Level 1
Level 1

I was wondering if someone could give me a better explanation of what the below commands do. The AP help for the command doesn't really help me a lot. Besides the textbook definition, when would you use them and when not to, what they're used for, real-life scenarios, etc....

bridge-group 1 subscriber-loop-control

bridge-group 1 block-unknown-source

bridge-group 1 source-learning

bridge-group 1 unicast-flooding

bridge-group 1 spanning-disabled

1 Reply 1

wdrootz
Level 4
Level 4

These commands are used for bridging purposes and are automatically enabled when you configure the Bridge-group command on the radio or the fast ethernet interface. These commands should not be disabled. Else the connectivity to the WLAN will not happen.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: