I was wondering if someone could give me a better explanation of what the below commands do. The AP help for the command doesn't really help me a lot. Besides the textbook definition, when would you use them and when not to, what they're used for, real-life scenarios, etc....
These commands are used for bridging purposes and are automatically enabled when you configure the Bridge-group command on the radio or the fast ethernet interface. These commands should not be disabled. Else the connectivity to the WLAN will not happen.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...