Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

AP1131 (Autonomous) 802.11a config for 7921 phones Help

Hi,

I would like to config 802.11a radio of AP1131 (Autonumus mode)  to work with 7921 ip phones. I have some doubts.

In 7921 deployment guide says that i should leave one channel of separation for adjacent AP's. How can i config that in autonomous mode? In 802.11B/G radio i can use comand channel X but und 802.11a interface i only have channel DFS.

I am in Europe what band should i use? Only a UNII-1 channel (channels 36, 40, 44, 48) ?

Is my interface config correct?

interface Dot11Radio1
no ip address
no ip route-cache
!
encryption vlan 20 mode ciphers tkip
!
ssid Voice
!
countermeasure tkip hold-time 0
dfs band 3 4 block
speed  basic-12.0 18.0 24.0 36.0 48.0 54.0
channel dfs
station-role root fallback shutdown
bridge-group 1
bridge-group 1 suno bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
bridge-group 1 spanning-disabled
service-policy input data_policy
service-policy output data_policy
!bscriber-loop-control
bridge-group 1 block-unknown-source

Any tips or suggestions would be great!

Thanks

Best Regards

MC.

4 REPLIES
Gold

Re: AP1131 (Autonomous) 802.11a config for 7921 phones Help

Make sure you add the command "admit-traffic" under the dot11 ssid config.

New Member

Re: AP1131 (Autonomous) 802.11a config for 7921 phones Help

Hi,

Thanks for you reply but my question is regarding what channels should i use in 802.11a and how to config them in AP1131 in autonomous mode.

Gold

Re: AP1131 (Autonomous) 802.11a config for 7921 phones Help

The 7921 supports UNII-1, UNII-2, UNII-2 extended, and UNII-3.  So you really can use any channel.

To configure the channel just:

config t

interface d1

channel <#>

New Member

Re: AP1131 (Autonomous) 802.11a config for 7921 phones Help

In 802.11b/g i can do that:

int dot0

channel #

But in 802.11a

I can only config channel dfs

How can i config channels staticly to config channels separation in adjacent AP's?

I'm in Europe and i saw in 7921 deploy guide that i only have 19 channels available in 802.11a so   it could mean that i souldn't use all UNII-1, UNII-2, UNII-2 extended, and UNII-3.

Thanks,

MC

830
Views
0
Helpful
4
Replies
CreatePlease to create content